• PT-2000BSA is a Low Current Surface Plasma Treatment System operating at Atmospheric Pressure and designed to significantly improve surface wettability of various nonconductive and conductive materials. It treats ID surface of various plastic articles. OD and flat surface treatments are also possible depending on the configuration

• The system consists of a high voltage electrode assembly with a set of nozzles, a plasma generator with a power supply, article indexing system and a process control panel

• In a standard configuration, PT-2000BSA is equipped with linear slide and part tailored carriers. Electrode is mounted vertically projecting the plasma stream directly into the articles indexing under the nozzles. Upon completion of a cycle slide returns to home position where it can be reloaded. Articles of specific sizes and geometry may require special modification/ construction of the electrode and feeding system. Multiple nozzles may be utilized for production rate increase and/or treatment improvement.

• PLC stores up to ten sets of optimized plasma parameters dedicated to specific treatment processes (recipes). A required recipe can then be easily selected from a list when changing, for example, from treatment of one specific part to another.

• During the treatment cycle PLC monitors all process parameters and alarms if any goes out of range. The system records original setup parameters, all changes in the corresponding recipes, and the alarms. Log file can be downloaded to a regular computer via ethernet connection

• Plasma treated materials - PTFE, FEP, ETFE, XL ETFE, Silicon, PE, PP, PET, ABS, Quartz, Glass, etc.

• Standard set of nozzles - Round 1/16, 1/8 and ¼”I.D. Tee ¼ “I.D. Flat flare 0.5, 1, and 3”

• Plasma Potential - 10-30KV

• Plasma Frequency - 10-30KHz

• Primary Plasma Gases - Argon, Helium

• Typical Gas Consumption (scfh) - 10-20 , 30 MAX

• Typical Gas Pressure (PSI) - 15-25 , 60 MAX

• Typical Power Consumption (W) - 100

• Typical Processing Speed (parts/min) - 1-10

• Part ID Diameter (um) - 100

• Length of ID Treatment (cm) - 0.1-100

• Dimensions (in) - 14x27x20

• Weight (lb.) - 75

• Power requirement - 120/250V, 60/50 Hz, 1 A

• Operating Environment - Temperature (35-105 oF), Humidity(90% max, non-condensing)